Processor One or two Intel® Xeon® processors with an 800MHz system bus.
System Memory
Memory Capacity Supports Registered ECC DIMMs that must be populated in pairs. DDR 266/333 - Six DIMM sockets for up to 24 GB of DDR 266 or 12 GB of DDR 333
DDR2 400 - Eight DIMM sockets for up to 16GB of DDR2 400.
Memory Type Registered ECC DDR 266/333 SDRAM 72-bit, 184-pin gold-plated DIMMs or registered ECC DDR2 400 72-bit, 240-pin gold-plated DIMMs
Reliability Features Corrects single-bit errors and detect double-bit errors (using ECC memory); supports x4 Intel® Single Device Data Connection (SDDC), scrubbing, retry on uncorrectable errors, memory mirroring, memory sparing4
Integrated On-Board
Chipset Intel® E7520 Chipset
Intel® Server Network Connections One Intel® 82541PI Gigabit Ethernet Controller and One Marvell* Yukon* -EC 88E8050 PCI Express* Gigabit Ethernet Controller, supporting teaming and failover, 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output.
Integrated Management Controller National Semiconductor* PC87431M Platform Instrumentation ASIC
Graphics ATI* RAGE* XL SVGA PCI video controller with 8 MB of video memory
Integrated Storage Support
Parallel ATA Single-channel ATA 100 (integrated single connector) supporting two IDE devices
Serial ATA Dual-channel SATA 100 (two connectors on the server board) supporting integrated mirroring and striping (RAID 0 and 1)
Ultra320 SCSI E7520BD2V and SE7520BD2VD2: One Ultra320/LVD channel via either the LSI Logic* 53C1020 or LSI Logic 53C1020A SCSI controller, with integrated mirroring and striping (RAID 0 and 1), and support for modular ROMB (Intel® RAID Controller SRCZCRX)6
SE7520BD2SCSI and SE7520BD2SCSID2: Two Ultra320/LVD channels via the LSI Logic 53C1030 SCSI controller and connected via two internal 68-pin-wide connectors; maximum data transfer 320 MB/sec on each Ultra320/LVD channel, with integrated mirroring and striping (RAID 0 and 1), and support for modular ROMB (Intel® RAID Controller SRCZCRX)6
Input/Output
PCI Six total slots6: one PCI Express x8, one PCI Express x4 (physical connector is a x8 slot), one PCI-X 133MHz, two PCI-X 100MHz, one PCI 32-bit/33MHz 5V
IDE One legacy IDE connector for support of up to two IDE devices
USB Two USB 2.0 ports2 (rear) and two USB ports via internal headers for up to four USB ports. SE7520BD2 and SE7520BD2SCSI have three USB 2.0 ports on the rear and two USB ports via internal headers.
Serial Ports One external DB9 serial port; one internal serial port (which can become Emergency Management Port if system-management card supports EMP)
Floppy Controller 1.44 MB and 2.88 MB, 3-mode support
Keyboard/Mouse Two PS/2 ports, 8240A-compatible
Intel® Server Management
Integrated Management Type Onboard Platform Instrumentation
Software Support Intel® Server Management family of software; upgradeable via custom add-in card to support Intel® Management Module.
Intel® Management Module Support Professional Edition, Advanced Edition
Supported Standards IPMI, DMI, CIM, SNMP, ICMB
Fully Validated Operating Systems Microsoft Windows Server* 2003 Enterprise Edition, Microsoft Windows 2000 Advanced Server, Red Hat* Linux* Enterprise 3.0, SUSE LINUX Enterprise Server 9, and Novell* NetWare* 6.5.
System BIOS
Type 4MB Flash ROM with AMI* BIOS, Multiboot BBS (BIOS Boot Specification).
Special Features Plug and Play, IDE drive auto-configure, SMBIOS 2.3, ECC/Parity support, multilingual support, enabled for Intel® One Boot Update for BIOS updates, flashable, integrated BIOS setup utility.
Configuration Utilities Server Configuration Wizard for system setup of BIOS utilities; Save and Restore System Configuration Utility and initial Intel® Server Management 8 configuration.
Jumpers CMOS clear, password clear, BIOS recovery
Front-Panel Support Power button, reset button, diagnostic interrupt (front-panel NMI) button, system identify button, system ID LED, status/fault LED, chassis-intrusio
|
|
